Common faults and maintenance of Golf Cart
2025,03,12
1. The meshing marks and tooth side clearance of the active and driven bevel gears of
Golf Cart do not match, the gears are damaged, and the bearings are excessively worn, which can cause abnormal noise.
2. The preload force of the
Lithium Golf Carts bearing is too large, the gear meshing side clearance is too small, the meshing mark is incorrect, and the lubricating oil is insufficient, which can cause abnormal heating. The vehicle should be allowed to leave only after timely elimination.
3. The tightness of each connection part of the Lithium Golf Carts should be checked frequently. If there is any looseness, it should be tightened immediately to avoid accidents.
4. Check whether there is lubricating oil leakage at each connection part of the Lithium Golf Carts frequently. If found, it should be eliminated in time.
5. The dirt outside the vent plug of the Lithium Golf Carts should be cleaned frequently to keep the air hole unobstructed. Check the amount of lubricating oil frequently, not too much or too little.
6. There are several main reasons for abnormal noise in the rear axle during the operation of the Lithium Golf Carts:
The half-shaft bearing is damaged, the bearing is replaced, the gear oil is insufficient or the gear oil has been used for a long time, the oil quality has changed, add gear oil or adjust the original gear oil, and inject the new gear oil and oil amount specified in the manual. The rear shock absorber is damaged and leaking oil, so replace it.